Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF User Manual
Page 43
37 |
CHAPTER 4 – CABLING A 685ix OR D685ix SYSTEM TO A HAWM-UX/UF
3. Secure the mobility switch cable using a Phillips No. 2 screwdriver and the two
screws listed inside the HAWM-UX/UF installation guide. Secure the cable toward
the side of the interactive whiteboard where you choose to mount the mobility
switch and make sure that the cable is toward the bottom of the switch as you
mount it.
4. Place the cable through the HAWM-UX/UF’s lower cable clip, making sure that the
cable is taut between the interactive whiteboard and the clip and loose between
the clip and the base of the HAWM-UX/UF.
5. Bundle the excess cable, making sure that there is a minimum of 28" (71.1 cm)
excess straight length or a 14" (35.6 cm) loose loop of cable.
Taut cable
Loose cable