Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 69)

63 | CHAPTER 5 – CABLING A 600I4 OR D600I4 SYSTEM TO A HAWM-UX/UF
11. If you don’t want to connect a network cable, proceed to the next step. Otherwise,
connect the other end of the network cable to your LAN port.
12. Connect the other end of the cables to your peripheral devices.
13. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cables aren’t taut at any range of the HAWM-UX/UF’s movement. If
it’s still taut, repeat this procedure until you find a suitable mounting location or
length for the cables.
Connecting composite video and USB devices to your
projector’s ECP
The ECP has three USB A jacks and one composite video RCA jack with associated
dual-channel audio RCA jacks. SMART recommends that you install only small USB
devices, such as a USB drive, or that you use a USB port on your computer for larger
devices to eliminate the risk of cable damage. SMART also recommends that you use
the composite video connector for temporary connections to peripheral devices, or
that you use a permanent connection to the projector’s connection panel.
To connect a composite
video device
1. Make sure that you place the device near the HAWM-UX/UF on a stable support.
2. Allow enough excess cable length to accommodate the HAWM-UX/UF’s rise and
descent, or make sure that the HAWM-UX/UF isn’t moved while the device is
attached.
3. When you’r e finished with the device, disconnect the cable from the ECP.