Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF User Manual
Page 39
34 |
CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF
6. Place the cables
around the back of
the HAWM-UX/UF
toward the left side
of the interactive
whiteboard if the
peripheral device or
LAN connector is
located on the left or
toward the right side
of the interactive
whiteboard if the
peripheral device or
LAN connector is
located on the right.
7. Attach the cables to
the lower cable clips
on the HAWM.
8. If you have many
cables attached, smoothly bundle your peripheral device cables together using a
cable tie (not included).
9. Attach a cable management clip (not included) to the cables or cable bundles,
making sure there’s a minimum of 28" (71.1 cm) excess straight length or a 14"
(35.6 cm) loose loop of cable.
10. If you don’t want to connect a network cable, proceed to the next step. Otherwise,
connect the other end of the network cable to your LAN port.
11. Connect the other end of the cables to your peripheral devices.
12. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cables aren’t taut at any range of the HAWM-UX/UF’s movement. If
they’re still taut, repeat this procedure until you find a suitable mounting location or
length for the cables.