Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 83)

77 | CHAPTER 6 – CABLING A 600I3 OR D600I3 SYSTEM TO A HAWM-UX/UF
To connect your host
computer’s audio and
video output to the
projector
1. Make sure you have VGA and 3.5 mm audio cables (not included) long enough to
connect your computer to your SMART UF55 or SMART UF55w projector.
2. Pass the VGA and audio cables through the boom and connect your VGA cable to
the Computer (VGA) 2 input on your projector.
3. Connect your 3.5 mm audio cable to the Audio 2 input on your projector.
4. Secure the cables to the SMART UF55 or SMART UF55w projector’s wall-mount
bracket using a cable tie. Place the cables through the cable cutouts on the
bottom wall-mount bracket.
5. Place the cables
around the back of
the HAWM-UX/UF
toward the left side
of the interactive
whiteboard if your
computer is located
on the left or toward
the right side of the
interactive
whiteboard if your
computer is located
on the right.
6. If you have many
cables attached,
smoothly bundle
your peripheral
device cables
together using a
cable tie (not included).
7. Connect the other ends of your VGA and audio cables to your computer’s video
output connector.
8. Attach a cable management clip (not included) to the cables or cable bundles,
making sure that there’s a minimum of 28" (71.1 cm) excess straight length or a
14" (35.6 cm) loose loop of cable.
9. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cables aren’t taut at any range of the HAWM-UX/UF’s movement.
If the cables are still taut, repeat this procedure until you find a suitable mounting
location or length for the cables.