Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 67)

61 | CHAPTER 5 – CABLING A 600I4 OR D600I4 SYSTEM TO A HAWM-UX/UF
Connecting the power, network and other peripheral device
cables to your SMART UF65 or SMART UF65w projector
Peripheral devices that don’t mount on the HAWM-UX/UF but that connect to your
projector’s connection panel on the HAWM-UX/UF require a certain amount of slack in
the cable for the projector’s rise and descent. When connecting your projector’s power
cable, don’t bundle it with or place it parallel to other peripheral device cables you
attach to your projector. If the wires cross or travel the same path, make sure it is
placed perpendicular (at right angles) to other unpowered cables.
To connect your projector
power cable on the
HAWM-UX/UF
1. Pass the power
cable through the
boom and then
connect it to the
power socket. Make
sure that the power
cable is in the far
right position in the
cable slot.
2. Secure the power cable to the SMART UF65 or SMART UF65w projector’s
wall-mount bracket using a cable tie. Place the cable through the cable cutouts on
the wall-mount bracket.
3. Place the power cable around the back of the HAWM-UX/UF toward the left side
of the interactive whiteboard if the power outlet is located on the left, or toward the
right side of the interactive whiteboard if the power outlet is located on the right.
4. Connect the other end of the power cable to a power outlet no more than 72"
(183 cm) away from the projector. This distance includes the amount of slack you
need for the projector’s range of movement. If necessary, use a power cable
extension of an appropriate length that includes a minimum of 28" (71.1 cm)
excess straight length or a 14" (35.6 cm) loose loop of cable.
5. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cable isn¹t taut at any range of the HAWM-UX/UF’s movement.
TIP
Find a support location for the power cable that doesn’t interfere with the
movement of the HAWM-UX/UF and attach a cable management-clip (not
included) to the cable. Make sure that you have enough slack for the
HAWM-UX/UF to move freely and then bundle the excess. This is strongly
recommended.
Cable slot