Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF User Manual
Page 22
18 |
CHAPTER 2 – CABLING AN 885ix SYSTEM TO A HAWM-UX/UF
NOTES
•
SMART recommends that you use a VGA out connector on your source input,
to simplify the cable placement.
•
The HDMI connector is intended for non-interactive audio-video content only,
such as high-definition DVD/Blu-ray players. If you connect a cable from the
HDMI port to a computer, your SMART Board interactive whiteboard doesn’t
recognize touch commands.
Using the SMART UX60 projector ECP for other components
The following diagram and list identify the ECP connections to components that aren’t
mounted to the HAWM-UX/UF.
Connecting the power, network and other peripheral device
cables to your projector
All cables that connect to your HAWM-UX/UF projector’s connection panel require a
certain amount of slack to accommodate the projector’s rise and descent. When
connecting your projector’s power cable, don’t bundle it with or place it parallel to
other peripheral device cables you attach to your projector. Any cables that travel the
same path must be placed perpendicular (at right angles) to other unpowered cables
to reduce signal interference.
Number
Function
1
USB A jack (for USB drives)
2
Power button and status light
3
Volume control
4
Input selection
5
Two mini USB B jacks (connect to computers 1 and 2)
6
11-pin connector (connects to ECP harness cable)
7
4-pin connector (for room control)
2
3
4
5
7
6
1