Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 62)

56 | CHAPTER 5 – CABLING A 600I4 OR D600I4 SYSTEM TO A HAWM-UX/UF
To connect your
projector’s ECP harness
cables
1. Pass the ECP cable through the
cable slot.
NOTE
The upper part of the ECP cable
is too thick to fit inside the cable
slot, so put the thinner part of the
ECP cable in the cable slot.
2. From the ECP harness cable, attach
the composite video RCA jack, its
associated dual channel audio input (two RCA jacks), the 4-pin power mini-DIN
connector and the 7-pin mini-DIN connector to the projector’s connection panel.
3. Attach the screw on the ECP strain relief to the projector housing using a Phillips
No. 2 screwdriver.
4. Using a cable tie, secure the power cable to the SMART UF65 or SMART UF65w
projector’s wall-mount bracket. Place the cable through the cable cutouts on the
wall-mount bracket.
5. Place the harness cable around
the back of the HAWM-UX/UF’s
interactive whiteboard brackets,
toward the left side of the
interactive whiteboard if the ECP is
mounted on the left, or toward the
right side of the interactive
whiteboard if the ECP is mounted
on the right.
6. Place the harness cable through
the upper cable clips you installed
on the side of the HAWM-UX/UF.
7. Connect the harness cable’s
DB15M plug to the ECP’s DB15
connector.
Cable clips