SmartBridges sB3021 User Manual
Page 34
Page 34 of 113
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul
2
Nexus PRO™ User Guide
Figure 2-19 Changing Root Bridge to Remote Bridge
2.6.2 Root Bridge to Remote Router/NAT
Follow the steps below to change Root Bridge mode to Remote Router/NAT mode:
1 Go
to
Tools | System Configuration drop down menu. The System Configuration will be
displayed as shown below.
2
Alternatively, click on the Current Device Mode link on the top right hand corner to go to the
System Configuration page.
3 Click on the Current Operational Mode and select the radio that has to be configured as
Remote Router/NAT. Click on Apply Changes. A confirmation pop-up window will be
displayed.
4 Enter IP Address, IP Mask for Ethernet Configuration, the IP Address, IP Mask and
Gateway for the wireless configuration. By default the DHCP is disabled and if required, it can
be enabled.
5 Click on the Apply Changes button to change the settings. The device will be rebooted and
set to the chosen operational mode.
Note: Before changing one radio to remote, the other radio needs to be changed to root bridge
before doing a apply change.