SmartBridges sB3021 User Manual
Page 40
Page 40 of 113
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul
2
Nexus PRO™ User Guide
Figure 2-27 Changing Remote Router/NAT to Remote Bridge
2.6.6 Remote Bridge to Remote Router/NAT
Follow the steps below to change Remote Bridge mode to Remote Router/NAT mode
1 Go
to
Tools | System Configuration drop down menu. The System Configuration will be
displayed as shown below.
2 Alternatively, click on the current device mode link on the top right hand corner to go to the
System Configuration page.
3
Click on “Current Operational Mode”, Select the Radio that has to be configured as Remote
Router/NAT and click on Apply Changes. A confirmation pop-up window will be displayed.
4 Enter IP Address, IP Mask for Ethernet Configuration, and the IP Address, IP Mask and
Gateway for the Wireless configuration. By default the DHCP is disabled and can be enabled
if required.
5 Click on the Apply Changes button to change the settings. The device will be rebooted and
set to the chosen operational mode.