SmartBridges sB3021 User Manual
Page 39
Page 39 of 113
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul
2
Nexus PRO™ User Guide
2.6.5 Remote Router/NAT to Remote Bridge
Follow the steps below to change Remote Router/NAT mode to Remote Bridge Mode:
1 Go
to
Tools | System Configuration drop down menu. The System Configuration will be
displayed as shown below.
2 Alternatively, click on the current device mode link on the top right hand corner to go to the
System Configuration page.
3 Click on “Current Operational Mode”, select the radio that has to be configured as Remote
Bridge and click on Apply Changes. A confirmation pop-up window will be displayed.
4 Enter IP Address, IP Mask and Gateway for Ethernet Configuration. DHCP is disabled by
default and can be enabled if required.
5 Click on the Apply Changes button to change the settings. The device will be rebooted and
set to the chosen operational mode.
Figure 2-26 System Configuration Page--Remote Router/NAT to Remote Bridge