SmartBridges sB3021 User Manual
Page 37
Page 37 of 113
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul
2
Nexus PRO™ User Guide
Figure 2-23 Changing Remote Bridge to Root Bridge
2.6.4 Remote Router/NAT to Root Bridge
Follow the steps below to change Remote Router/NAT mode to Root Bridge mode:
1 Go
to
Tools | System Configuration drop down menu. The System Configuration will be
displayed as shown below.
2 Alternatively, click on the current device mode link on the top right hand corner to go to the
System Configuration page. .
3 Click on the “Current Operational Mode”, Select the Radio that has to be configured as
Root Bridge and click on Apply Changes. A confirmation pop-up window will be displayed.
4 Enter the IP Address, IP Mask and Gateway for Ethernet Configuration. DHCP is disabled
by default and can be enabled if required.
5 Click on the Apply Changes button to change the settings. The device will be rebooted and
set to the chosen operational mode.