SmartBridges sB3021 - Manual (Page 52)

Page 52 of 113
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul 2 Nexus PRO™ User Guide
2.8 Remote Bridge Configuration
The airHaul
2
Nexus PRO units can also be configured to operate as a Remote device to associate
with a Root Bridge.
2.8.1 Bridge IP Configuration
The Ethernet IP is configured during the operational mode change to Remote Bridge mode.
Follow these steps below if you need to re-configure the Remote Bridge Ethernet parameters:
1. From the Summary Information page, click on the Bridge IP Configuration link to change
Ethernet parameters.
2. Enable or disable the DHCP by clicking the check box. Enter the ‘IP Address’, ‘IP mask’,
‘Gateway’ for non DHCP. Assign the unit a unique IP Address with the same IP subnet (e.g.
192.168.0.100) as the Root device it will be associated to.
3. Click on the ‘Apply Changes’ button to change the settings.
Figure 2-36 Remote Bridge Ethernet Configuration