Sun Microsystems Sun Fire X4200 - Manual (Page 121)

Chapter 9 System Monitoring and Maintenance Using the SP GUI 9-15
2. To modify an alert:
a. Click a radio button to select an alert in the table.
b. Click the Edit button.
The Alert dialog box appears.
FIGURE 9-8 Event Severity
c. Select an event severity from the drop-down list box.
d. Type the destination IP address for the alert.
e. Click Save.
The modified alert appears in the Alert Destinations table.
3. To simulate that an alert was sent:
a. Click a radio button to select an alert in the table.
b. Click the Send Test Alert button.
A confirmation dialog box indicates that the alert was sent to the specified IP
address.
c. Click OK to verify that the alert was sent successfully.