Sun Microsystems Sun Fire X4200 - Manual (Page 154)

11-10 Sun Fire X4100 and Sun Fire X4200 Servers System Management Guide • December 2005
4. Once you have uploaded the certificate and private key, click OK to reset the
service processor immediately, or click Cancel to reset the service processor later.
The service processor must be reset for the new certificate to take effect. If you click
OK, you must close your Internet browser and reconnect to the service processor.
HTTPS is enabled by default.
You can now access the service processor securely using the following format in
your IP Address field from your Internet browser:
https:// <service processor IP address>
For example, if the service processor’s IP address is 192.168.0.30, enter the following:
https://192.168.0.30
Note – Ensure that you include the "s" after http.
11.6 How to Enable HTTP or HTTPS Web
Access
This section explains how to view and modify web server settings. Hypertext
Transfer Protocol (HTTP) and Hypertext Transfer Protocol Secure (HTTPS) enable
you to retrieve hypertext messages from client to server and server to client. Both
protocols are based on the Transmission Control Protocol/Internet Protocol
(TCP/IP). HTTPS is an extension of HTTP that uses Secure Sockets Layer (SSL) to
enable secure transmissions over a TCP/IP network. HTTPS is enabled by default.
11.6.1 Before You Begin
Log in to the service processor (SP) as Administrator to reach the ILOM web GUI.
Only accounts with Administrator privileges are enabled to set the HTTP or HTTPS
web server.
11.6.2 What to Do
1. From the Configuration tab, select System Management Access, then Web Server.
The Web Server Settings page appears.