Maintenance, Safety precautions, Routine and periodic maintenance – Lincoln Electric IDEALARC CV-300 User Manual
Page 30: Warning
D-1
MAINTENANCE
D-1
SAFETY PRECAUTIONS
•
Have a qualified technician do the maintenance
and troubleshooting work.
•
Disconnect input power at main input supply
prior to working inside machine.
____________________________________
Read the Safety Precautions in the front of this manu-
al before working on this machine.
ROUTINE AND PERIODIC
MAINTENANCE
1.
Disconnect input AC power supply lines to the
machine before performing periodic maintenance,
tightening, cleaning, or replacing parts. See
Figure D.1.
Perform the following daily:
1.
Check that no combustible materials are in the
welding or cutting area or around the machine.
2.
Remove any debris, dust, dirt, or materials that
could block the air flow to the machine for cooling.
3.
Inspect the electrode cables for any slits, punc-
tures in the cable jacket, or any condition that
would affect the proper operation of the machine.
Perform Periodically:
Clean the inside of the machine with low pressure air
stream. Clean the following parts. Refer to Figure D.1.
Main transformer and choke.
Electrode and work cable connections.
SCR rectifier bridge and heat sink fins.
Control board.
Fan Motor Assembly.
NOTE: The fan motor has sealed bearings which
require no maintenance.
IDEALARC CV-300
WARNING