Warning, Installation, Safety precautions – Lincoln Electric IDEALARC CV-300 User Manual
Page 9: Select proper location, Stacking, Tilting
Read entire Installation Section before installing
the IDEALARC CV-300.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Only qualified personnel should
install this machine.
• Turn the input power OFF at the dis-
connect switch or fuse box before
working on the equipment.
•
Turn the Power switch on the CV-300 “OFF”
before connecting or disconnecting output
cables, wire feeder or remote connections, or
other equipment.
•
Do not touch electrically hot parts.
•
Always connect the IDEALARC CV-300 ground-
ing terminal (located on the welder base near
the reconnect panel) to a good electrical earth
ground.
____________________________________
SELECT PROPER LOCATION
The IDEALARC CV-300 can be used indoors or out-
doors. It has an IP-23 degree of protection.
Place the IDEALARC CV-300 where clean, cooling air
can freely circulate in through the side louvers and out
through the rear louvers. Dirt, dust, or any foreign
material that can be drawn into the machine should be
kept at a minimum. Not following these precautions
can result in the nuisance shutdown of the machine
because of excessive operating temperatures.
STACKING
Three IDEALARC CV-300 machines can be stacked.
DO NOT stack more than three machines in one
grouping.
DO NOT stack the IDEALARC CV-300 on another type
of machine.
A-2
INSTALLATION
IDEALARC CV-300
A-2
Follow these guidelines when stacking:
1.
Select a firm, level surface capable of supporting
the total weight of up to three machines.
2.
Set the bottom machine in place.
3.
Stack the second machine on top of it by aligning
the two holes in the base rails of the second
machine with the two pins on top of the bottom
machine.
4.
Repeat process for third machine.
NOTE: The machines must be stacked with the Case
Front of each machine flush with each other. See
Figure A.1.
FIGURE A.1 - Stacking IDEALARC CV-300
machines.
TILTING
The IDEALARC CV-300 must be placed on a stable,
level surface so it will not topple over. Do not place the
machine on an incline.
STACKING HOLE
STACKING PIN
WARNING