Lexmark 4I3 - Manual (Page 101)

Adjusting the Tear-off Position
The Dual Purpose Forms Device Document on Demand features
allow you to tear off a form using the tear bar upon completing a
print job. You can then prepare the printer to print the next print job.
Te a r B a r
To change the tear-off position of a form, follow these steps:
1. Make sure the printer is at the top of form position. Press
Load/Eject once.
The printer displays
and the Ready indicator goes off. The paper quickly advances
to the tear-off position.
| If you have Models 4I3 and 5I3, you can also use the Automatic
| Eject or Automatic Restore options to change the tear-off
| position of a form. See IBM 4230 Printer Models 102, 1I1, 202,
| 2I1, 4I3, and 5I3 Operator Panel Instructions for more
| information on these options.
2. Open the acoustic cover.
3. If the perforation on the form is not at the tear-off position, use
the Micro , Micro , and Line Feed keys to adjust the form
position until the perforation is exactly in line with the tear-off bar.
3 FORMS EJECTED
PRESS LOAD
Chapter 1. Setting Up the 4230 Printer 1-79