Lexmark 4I3 - Manual (Page 43)

Installing and Using the Continuous Forms Device
(F1)
The following sections describe how to install and use the
Continuous Forms Device (F1).
Note: Make sure that the proper forms device is configured. See
“Preparing for Forms Device Installation” on page 1-10 for the exact
steps.
Installing the Continuous Forms Device (F1)
To install the F1 forms device, follow these steps:
1. Hold the forms device so that the device number F1 is in the
upper left corner facing you. Note the bottom metal bar and the
clips; they will be important later.
2. Remove the orange shipping clip, if installed.
Important
The F1 forms device for the 4230 Printer has a circle around
the F1 emblem. Use only these forms devices in the 4230
Printer.
To p o f F o r m s D e v ic e
B o t to m M e ta l B a r
C lip s
F1
Te n s io n e r P la t e s
Chapter 1. Setting Up the 4230 Printer 1-21