Lexmark 4I3 - Manual (Page 142)

Models 102, 1I1, and 4I3 Twinaxial Attachment
Supported computers include:
System/36
Application System/400* (AS/400*)
5294 and 5394 Remote Control Units.
Attaching a Twinaxial Signal Cable to the Printer
To attach a twinaxial cable (not shipped with the printer), follow these
steps:
1. Set the address. If your desired printer address is 0, go to Step
3 on page 2-4. If your desired printer address is not 0, see the
following table for the valid values and follow Steps 1a on
page 2-3 through 1g on page 2-4 to change the value. If you
do not know what to assign for the printer address, check with
your system operator.
If Desired
Address Is:
Set: Shown when Setting
Printer Address:
0 000 Printer Address=0
1 001 Printer Address=1
2 002 Printer Address=2
3 003 Printer Address=3
4 004 Printer Address=4
5 005 Printer Address=5
6 006 Printer Address=6
2-2 User’s Guide