Lexmark 4I3 - Manual (Page 255)

This is an informational message. The printer displays this message
after you press Load/Eject to eject the forms when F2 Eject Mode is
set to
Delayed Eject . See “Selecting Performance Parameters” in
IBM 4230 Printer Models 102, 1I1, 202, 2I1, 4I3, and 5I3 Operator
Panel Instructions.
The printer displays
after the forms are ejected.
This message displays when Hex Print is pressed and the print
quality is set to Near Letter Quality. Change the print quality to Data
Processing (DP) to enable the use of this function.
93 EJECT PENDING
3 FORMS EJECTED
PRESS LOAD
94 FUNCTION NOT AVAILABLE
Change Print Quality to DP
Appendix B. Problems B-25