Lexmark 4I3 - Manual (Page 38)

Operator Note
If you turned the power Off (O) and back On (|) in less than
10 seconds, the display may be blank or a message may
appear.
If the power-on messages do not appear in your language,
see “Using Printer Setup Parameters” in IBM 4230 Printer
Models 102, 1I1, 202, 2I1, 4I3, and 5I3 Operator Panel
Instructions to change the Display Language.
a. Did the printer come on after you turned the power On (|) in
Step 4 on page 1-14?
If Yes, go to Step 5b.
If No, perform Steps 5a1 through 5a6.
1) Turn the power Off (O).
2) Unplug the printer power cord from the electrical outlet.
3) Be sure that the power cord is firmly connected to the
rear of the printer.
4) Try another electrical device (such as a lamp) in the
outlet.
5) If the outlet is working, connect the printer to the outlet
again. Return to Step 4 on page 1-14 and try again.
6) If the printer still fails to come on, call your service
representative.
b. Did the printer display a code or message and did the same
code or message remain on the display after approximately
30 seconds?
If Yes, go to Appendix B, “Problem Solving,” find the
status code or message the printer displayed, and follow
the instructions.
If No, go to Step 5c on page 1-17.
1-16 User’s Guide