Lexmark 4I3 - Manual (Page 225)

Guideline for Training
To introduce a new operator to the printer, use the following steps as
a guideline. Change the steps, as needed, to suit your working
environment and the operator’s level of responsibility.
1. Show the operator this guide and discuss the contents of
Chapter 1, “Setting Up the 4230 Printer.”
2. Show the operator
IBM 4230 Printer Models 102, 1I1, and 4I3 Quick Reference
Guide or IBM 4230 Printer Models 202, 2I1, and 5I3 Quick
Reference Guide (depending on the model installed)
IBM 4230 Printer Models 102, 1I1, 202, 2I1, 4I3, and 5I3
Operator Panel Instructions
and discuss the contents of each.
3. The power cord should be unplugged before connecting or
disconnecting the signal cable. See Chapter 1, “Setting Up the
4230 Printer” for the proper sequence.
4. Show the operator how to install the forms device with emphasis
on identifying the type of forms device (F1, F2, F3, or F4). Show
the operator where the procedures are in Chapter 1, “Setting Up
the 4230 Printer” or in IBM 4230 Printer Auto Sheet Feeder
General Information (depending on the forms device installed).
5. Show the operator how to set the forms device number. Show
the operator where the procedures are in Chapter 1, “Setting Up
the 4230 Printer” or in IBM 4230 Printer Auto Sheet Feeder
General Information (depending on the forms device installed).
Appendix A. Training Guideline A-3