LevelOne GSW-2600TXM - Manual (Page 112)

112
Switch Information Shows hardware / firmware version numbers, power status, and
expansion modules used in the switch.
Management Setup Menu
Network
Configuration¹
Configures the switch’s network parameters.
Serial Port
Configuration Sets communication parameters for the serial port, including
baud rate, console timeout, and screen data refresh interval.
SNMP Configuration Activates authentication failure traps, configures community
access strings and trap managers.
User Configuration Sets the user names and passwords for system access.
TFTP Download Downloads new version of firmware to update your system
(in-band).
Configuration File Saves or restores configuration data based on the specified file.
Device Control Menu
System Mode³
Sets the switch to operate as a Layer 2 switch or as a multilayer
routing switch.
Layer 2 Menu Configures port communication mode, mirror ports, port trunking,
and static addresses.
Bridge Menu Configures GMRP and GVRP for the bridge, as well as Spanning
Tree settings for the global bridge or for specific ports.
VLAN Menu Configures VLAN settings for specific ports, and defines the port
membership for VLAN groups.
IGMP Snooping
Configuration¹ Configures IGMP multicast filtering.
IP Menu² Configures the subnets for each VLAN group, global
configuration for ARP and ARP proxy, unicast and multicast
protocols, BOOTP / DHCP relay, static ARP table entries, static
routes and the default route.
Security Menu Configures MAC and IP² address filtering.
Network Monitor Menu
Port Statistics
Displays statistics on port traffic, including information from the
Interfaces Group, Ethernet-like MIB, and RMON MIB.
Layer 2 Address
Table Contains the unicast address table.
Bridge Menu Displays Spanning Tree information for the overall bridge and for
specified ports.
VLAN Menu Displays dynamic port registration information for VLANs, as well
as all VLAN forwarding information for static and dynamic
assignment.
IP Multicast
Registration Table¹ Displays all the multicast groups active on this switch, including
the multicast IP addresses and corresponding VLANs.
IP Menu² Displays all the IP subnets used on this switch, as well as the
corresponding VLANs and ports. Also contains the ARP table,
routing table, multicast table, and OSPF table.