LevelOne GSW-2600TXM - Manual (Page 53)

53
Modify Subnet
=============
VLAN : 1 Select
IP Address : 192.168.1.254
Subnet Mask : 255.255.255.0
Proxy ARP : DISABLED
RIP : DISABLED Advanced ...
OSPF : DISABLED Advanced ...
DVMRP : DISABLED Advanced ...
<Delete> <Apply> <OK>
<Cancel>
VLAN ID.
| READ/WRITE
Use <TAB> or arrow keys to move, other keys to make changes.
Configuring RIP
The Routing Information Protocol is used to specify how routers exchange routing table
information. (See “RIP and RIP-2 Dynamic Routing Protocols” on chapter 4.) When RIP
is enabled on this routing switch, it broadcasts RIP messages to all devices in the
network every 30 seconds, and updates its own routing table when RIP messages are
received from other routers. RIP messages contain both the IP address and a metric for
each destination network it knows about. The metric indicates the number of hops from
this device to the destination network.
You can use the following menu to specify authentication, the protocol used for sending
or receiving routing messages on this port, the default metric used in calculating the
best path, and enable or disable Poison Reverse.