LevelOne GSW-2600TXM - Manual (Page 156)

156
Oversize Frames The total number of frames received that were longer than
1518 octets (excluding framing bits, but including FCS octets)
and were otherwise well formed.
Fragments The total number of frames received that were less than 64
octets in length (excluding framing bits, but including FCS
octets) and contained either an FCS or alignment error.
Jabbers The total number of frames received that were longer than
1518 octets (excluding framing bits, but including FCS octets),
and contained either an FCS or alignment error.
Collisions The best estimate of the total number of collisions on this
Ethernet segment.
64 Byte Frames The total number of frames (including bad packets) received
and transmitted that were 64 octets in length (excluding
framing bits but including FCS octets).
65-127 Byte Frames
128-255 Byte Frames
256-511 Byte Frames
512-1023 Byte Frames
1024-1518 Byte Frames
1519-1536 Byte Frames The total number of frames (including bad packets) received
and transmitted where the number of octets fall within the
specified range (excluding framing bits but including FCS
octets).
Note:
Statistics are refreshed every 10 seconds by default (chapter 3 “Configuring the
Serial Port”).
3.7.2.Layer 2 Address Table
This menu includes the unicast address table.
Menu Description
Unicast Address Table
Provides a full listing for unicast addresses.
3.7.2.1.Displaying the Unicast Address Table
The Unicast Address Table contains the MAC addresses associated with each port that
is, the source port associated with the address). The information displayed in the
Address Table is indicated in the following figure and table.
Parameter Description
Address
The MAC address of a node seen on this switch.
Port The port whose address table includes this MAC address.