LevelOne GSW-2600TXM - Manual (Page 15)

15
SNMP Configuration Activates authentication failure traps; configures community
access strings, and trap managers.
User Configuration Sets the user names and passwords for system access.
TFTP Download Downloads new version of firmware to update your system
(in-band).
Configuration File Saves or restores configuration data based on the specified file.
Device Control Menu
System Mode³ Sets the switch to operate as a Layer 2 switch or as a multilayer
routing switch.
Layer 2 Menu Configures port communication mode, mirror ports, port
trunking, and static addresses.
Bridge Menu Configures GMRP and GVRP for the bridge, as well as
Spanning Tree settings for the global bridge or for specific
ports.
VLAN Menu Configures VLAN settings for specific ports, and defines the
port membership for VLAN groups.
IGMP Snooping
Configuration¹ Configures IGMP multicast filtering.
IP Menu² Configures the subnets for each VLAN group, global
configuration for ARP and ARP proxy, unicast and multicast
protocols, BOOTP / DHCP relay, static ARP table entries, static
routes and the default route.
Security Menu Configures MAC and IP address filtering. And configures the
learning function and Uplink port.
Network Monitor Menu
Port Statistics Displays statistics on port traffic, including information from the
Interfaces Group, Ethernet-like MIB, and RMON MIB.
Layer 2 Address Table Contains the unicast address table.
Bridge Menu
Displays Spanning Tree information for the overall bridge and
for specified ports.
VLAN Menu Displays dynamic port registration information for VLANs as
well as VLAN forwarding information for static and dynamic
assignment.
IP Multicast
Registration Table¹ Displays all the multicast groups active on this switch, including
the multicast IP addresses and corresponding VLANs.
IP Menu² Displays all the IP subnets used on this switch, as well as the
corresponding VLANs and ports. Also contains the ARP table,
routing table, multicast table, and OSPF table.
Restart System Restarts the system with options to restore factory defaults.
Exit Exits the configuration program.
1. Only display when intelligent switch is set to Layer 2 mode or the switch is
management model.
2. Only display when intelligent switch is set to multilayer mode.