LevelOne GSW-2600TXM - Manual (Page 68)

68
IGMP
Group
Timeout 5 The time between last spotting an IGMP Report message for an
IP multicast address on a specific port and the switch removing
that entry from its list.
Range: 3 - 5 minutes
2.5.6.3.Static ARP Configuration
Use the following screen to display or edit entries in the Static ARP Table. Entries added
to this table are retained until the associated IP interface is deleted or the switch is reset
to the factory defaults.
Static ARP Table
================
IP Address MAC Address Interface
Page 1 <Apply> Total 0 Pages
<OK> <Prev Page> <Next Page> <Add>
Return to previous panel.
Use <Enter> to select.
Parameter Description
IP Address IP address statically mapped to a physical MAC address.
MAC Address MAC address statically mapped to the corresponding IP address.
Interface The index number of the IP interface that will use this static ARP entry.
See chapter 2 “Subnet Configuration” or “Routing Table”. (Port “0”
refers to the CPU.)
2.5.6.4.Static Route Configuration
This switch can be configured to dynamically learn the routes to other IP networks,
subnets or hosts using unicast or multicast routing protocols. If the route to a specific
destination cannot be learned via these protocols or you wish to restrict the path used
for transmitting traffic to a destination, it can be statically configured using the Static
Route Table.
Before defining a static route, remember that you must first configure at least one IP
interface on this switch (chapter 2 “Subnet Configuration”). Static routes take
precedence over dynamically learned routes and remain in the table until you remove