LevelOne GSW-2600TXM - Manual (Page 66)

66
OSPF Host Route Configuration
=============================
IP Address Cost Area ID
Page 1 <Apply> Total 0 Pages
<OK> <Prev Page> <Next Page> <Add>
The page number.
|READ/WRITE
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Description
IP Address The IP address of this host.
Cost The link state cost of this host.
Area ID The area that the host belongs to.
Configuring BOOTP / DHCP Relay
If a DHCP / BOOTP server is not located in the same subnet with a host, you can
configure this switch to forward any host configuration queries to a server located on
another subnet or on another network. Depending on the configuration setup, the switch
either:
• Forwards the packet to a preferred server as defined in the switch configuration
using unicast routing, or
• Broadcasts the DHCP Request again to another directly attached IP subnet
specified in the switch configuration.
Specify the address for any DHCP server, or specify the subnet address for an
outbound IP interface already configured on this switch (chapter 2 “Subnet
Configuration”) as described in the following screens.