LevelOne GSW-2600TXM - Manual (Page 20)

20
IP Configuration
================
Interface Type : Ethernet
IP Address : 192.168.1.254
Subnet Mask : 255.255.255.0
Gateway IP : 0.0.0.0
IP State : USER-CONFIG
Mgt. Access : All
VLANs
<Apply> <OK> <Cancel>
IP address of this system for Ethernet. |
READ/WRITE
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter Description
Interface Type
Indicates IP over Ethernet.
IP Address IP address of the switch you are managing. The system supports
SNMP over UDP / IP transport protocol. In this environment, all
systems on the Internet such as network interconnection devices
and any PC accessing the agent module (or running network
management software) must have an IP address.
Valid IP addresses consist of four numbers, 0 to 255, separated by
periods. Anything outside this format will not be accepted by the
configuration program.
Subnet Mask Subnet mask of the switch. This mask identifies the host address
bits used for routing to specific subnets.
Default Gateway Gateway used to pass trap messages from the system’s agent to
the management station. Note that the gateway must be defined
(when operating at Layer 2) if the management station is located in
a different IP segment.
IP State Specifies whether IP functionality is enabled via manual
configuration, or set by Boot Protocol (BOOTP). Options include:
USER-CONFIG IP functionality is enabled based on the default
or user specified IP Configuration.
(This is the default setting.)
BOOTP Get IP IP is enabled but will not function until a BOOTP
reply has been received. BOOTP requests will
be broadcast periodically by the switch in an
effort to learn its IP address.
(BOOTP values can include the IP address,
default gateway, and subnet mask.)
Mgt. Access Allows management access of the switch from all VLANs or only