LevelOne GSW-2600TXM - Manual (Page 158)

158
Forward Delay The maximum time (in seconds) the root device will wait before
changing states (i.e., listening to learning to forwarding).
Hold Time The minimum interval between the transmission of consecutive
Configuration BPDUs.
Designated Root The priority and MAC address of the device in the Spanning Tree
that this switch has accepted as the root device.
Root Cost The path cost from the root port on this switch to the root device.
Root Port The number of the port on this switch that is closest to the root.
This switch communicates with the root device through this port. If
there is no root port, then this switch has been accepted as the
root device of the Spanning Tree network.
Configuration
Changes The number of times the Spanning Tree has been reconfigured.
Topology Up Time The time since the Spanning Tree was last reconfigured.
3.7.3.2.Displaying the Current STA for Ports
The parameters shown in the following figure and table are for port STA Information.
Parameter Description
Type
Shows port type as:
100BASE-TX: 10BASE-T / 100BASE-TX
100BASE-FX: 100BASE-FX
1G BASE-SX/LX: 1000BASE-SX/LX (multimode/ single mode)
1G BASE-T:
1000BASE-T