Pioneer SX-LX03 - Manual (Page 129)

Additional information 07
129
En
Inputs of connected
TV and this receiver,
switches
automatically. Is HDMI Control set to On? The inputs of the connected TV or this receiver may
automatically switch to the player when playback starts on
the player or the menu screen (Home Media Gallery, etc.) is
displayed. If you do not want the inputs of the connected TV
and/or this receiver to switch automatically, set
HDMI
Control to Off (page 111).
Player cannot be
operated with remote
control. Is an AV receiver or amplifier
connected to the
CONTROL IN
terminal on the player’s rear
panel?
Operate with the remote control of the device connected to
the
CONTROL IN terminal.
Are you operating the remote
control from a point too far away
from the player? Operate from within 7 m of the remote control sensor.
Are the batteries dead? Replace the batteries (page 9).
Settings you have
made have been
cleared. • Have you disconnected the
power cord while the player’s
power was on?
• Has there been a power
failure? If the power cord is disconnected or there is a power failure
while the player’s power is on, the settings you have made
may be cleared. Always press
 STANDBY/ON on the
player’s front panel or  BD on the remote control and
check that POWER OFF has turned off from the player’s
front panel display before disconnecting the power cord. Be
particularly careful when the power cord is connected to the
AC outlet on another device because the player turns off in
conjunction with the device. We recommend plugging the
power cord into a wall outlet whenever possible.
After a disc is
inserted,
Loading
stays displayed and
playback does not
start.
Are there too many files
recorded on the disc? When a disc on which files are recorded is inserted,
depending on the number of files recorded on the disc,
loading may take several dozen minutes.
 is displayed in file
names, etc. The characters that cannot be displayed on this player are
displayed in
.
The DVD layer of BD
and DVD hybrid discs
cannot be played. Is Hybrid Disc Playback
properly set?
Set Hybrid Disc Playback to DVD (page 113).
The CD layer of BD
and CD hybrid discs
cannot be played. Is Hybrid Disc Playback
properly set?
Set Hybrid Disc Playback to CD (page 113).
The Hybrid Disc
Playback setting
cannot be changed
(displayed in gray).
Is a disc set in the disc tray? The Hybrid Disc Playback setting cannot be changed when
a disc is set. Remove the disc, then change the setting.
BDMV/BDAV
Playback Priority
setting cannot be
changed (displayed in
gray). Is a disc set in the disc tray? The BDMV/BDAV Playback Priority setting cannot be
changed when a disc is set. Remove the disc, then change
the setting.
Problem Check Remedy
LX03BD_2.book Page 129 Monday, July 28, 2008 4:30 PM