Additional information 11 – Pioneer SX-LX03 User Manual
Page 61
Additional information
11
61
En
English
Français
Deutsch
Nederlands
Italiano
Español
No audio signal is
output from
AUDIO
OUT jacks.
•
Audio input from
ANALOG RCA jacks cannot be output from AUDIO OUT
jacks.
No sound from
subwoofer.
•
Check the speaker level settings (see Channel level setting on page 43).
• SX-LX08 model only:
– Check subwoofer for correct connections (see Connect the speakers on
page 24).
– Be sure subwoofer's power is turned ON.
– Raise subwoofer's volume level.
Can’t operate using the
remote control.
• Replace the batteries (see Putting the batteries in the remote control on page 9).
• Operate within 7 m, 30° of the remote sensor (see Using the remote control on
page 9).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Check that there’s nothing mistakenly plugged into the
CONTROL IN jack.
• For operating the other Pioneer component connected to the
CONTROL OUT
jack of this unit, make sure that the control cable and either an HDMI or analog
audio cable are connected (page 49).
• If an object is placed on top of the touch sensor, the sensor will be activated, thus
disabling the remote control unit operations. If the action indicator remains
continuously lighted, remove any object sitting on the touch sensor panel.
The front panel display
and indicators do not
appear.
• If the display mode is set to
Auto Display, the display will automatically turn off
if no operation is performed for a period of one minute. Try performing an
operation.
Motion sensor not
working.
• The motion sensor is on the front of the unit. Make sure you are within 2.5 m and
40° of the sensor.
• Since the motion sensor uses infrared rays, it may not work correctly if placed in
direct sunlight or close to heat source.
• Minimum unit height must be 25 cm or above from ground level. The sensor will
not work properly when located at ground level.
• Motion sensor will not work if placed in a fully sealed cabinet (include glass /
clear cabinet).
Problem
Remedy
LX03BD_1.book Page 61 Monday, July 28, 2008 2:12 PM