Pioneer SX-LX03 - Manual (Page 84)

Getting Started 03
84
En
• When HDMI is selected for Video or
Audio, proceed to step 5.
• When Component Video is selected for
Video, proceed to step 6.
• When S-Video/Video is selected for
Video, proceed to step 7.
Caution
• When HDMI is selected for Video, no video
signals are output from the COMPONENT
VIDEO, S-VIDEO or VIDEO output
terminals.
• When Component Video or S-Video/
Video is selected for Video, no video
signals are output from the
HDMI OUT
terminal.
• The video and audio signals output from
the set output terminals are output
synchronously (lip synchronization).
• Linear PCM audio signals (2 channels) are
output from all terminals other than the
ones selected for
Audio, regardless of the
audio format or the player’s settings.
5 Select and set the HDMI High-
Speed Transmission setting.
Use
/ to select, then press ENTER.
• When HDMI High-Speed Transmission is
set to On, use the supplied HDMI cable or
a High Speed HDMI™ cable. The picture
and sound may not be output properly if
any other HDMI cable (standard HDMI™
cable) is used.
• When HDMI is selected for Video, proceed
to step 8.
• When Component Video is selected for
Video, proceed to step 6.
• When S-Video/Video is selected for
Video, proceed to step 7.
6 Select the output video resolution
from the COMPONENT VIDEO output
terminals.
Use
/ to select, then press ENTER.
For details on the resolution settings, see
Switching the output video resolution on
page 87.
Setting item Output terminal name
Vid
e
o
HDMI HDMI Output
Component
Video Video Output Component
Video
S-Video/Video S-Video
Video
Audio
HDMI HDMI Output
Digital Audio Digital Audio
Output Optical
Analog Audio Audio Output (2 ch)
Audio Output (7.1 ch)
ENTER
Setup Navigator
BD PLAYER
Select the HDMI Hi-speed transmission setting.
Normally select [On] (Recommended).
Select [Off] if the video or audio of HDMI-connected
was not output in the test output.
On Off
ENTER
Setup Navigator
BD PLAYER
Select the output video resolution at the
Component video terminal.
If you select [Source Direct], the output
resolution is determined according to the
video format of the playing source.
LX03BD_2.book Page 84 Monday, July 28, 2008 4:30 PM