Pioneer SX-LX03 - Manual (Page 48)

Other connections 09
48
En
2 Select an audio input source.
Input sources are cycled through as shown
below:
3 If necessary, start playback of the
external source.
Outputting the sound of this
receiver to an external device
You can use the ANALOG AUDIO OUT jacks
to connect an analog audio component, such
as a tape player, and record the sound of the
receiver’s tuner, etc.
Line Output setting
Use to select the audio down-mix method
when outputting Dolby Digital multi-channel
sound sources from the
ANALOG AUDIO
OUT jacks. 1
1 Press SETUP.
2 Select ‘Sound Setup’, then press
ENTER.
3 Select ‘Line Output’, then press
ENTER.
4 Select a setting.
Select one of the following:
• Lo/Ro(Stereo) – A simple stereo downmix
(left-only/right-only, or Lo/Ro) is output
(suitable for playback on a two-channel
stereo system or on headphones).
• Lt/Rt – A surround-compatible downmix
(left-total/right-total, or Lt/Rt) of Dolby
multichannel sources is output, (suitable
for Dolby Surround Pro Logic or other
matrix decoding).
The
L.OUT indicator lights.
5 Press to exit.
LINE
Digital 1 OPT
Digital 2 OPT Digital 3 COAX
Analog
OUT
L
ANALOG
R
AUDIO OUT
IN
CONTROL
AC IN
R L
R
FRONT 4
L
SPEAKERS
SURROUND 8 SUB WOOFER 4
CENTER 4
To
analog input
Tape player, etc.
(LX03BD)
Note
1 • When the Line Output is switched to Lt/Rt, the sound function will be fixed at the current setting and cannot be changed.
The display will briefly flash Line Out Mode if an attempt is made to use a prohibited function.
• When the Line Output is to Lo/Ro(Stereo), the audio from the analog output jacks may be interrupted, depending on the
operation.
• When using DTS multi-channel sound sources, output is in
Lo/Ro(Stereo).
SETUP
TOOLS
ENTER
ENTER
ENTER
LX03BD_1.book Page 48 Monday, July 28, 2008 2:12 PM