Putting the batteries in the remote control, Using the remote control, Controls and displays 01 – Pioneer SX-LX03 User Manual

Page 9

Advertising
background image

Controls and displays

01

9

En

English

Français

Deutsch

Nederlands

Italiano

Español

ANGLE*
Press to switch the BD-ROM or DVD-Video
camera angles.

23 DISPLAY
Displays RDS information (page 41).

Displays song playback information when
using the iPod function.

After set the remote control operation switch to
BD, press to display the disc information.

24 Remote control operation selector switch
Set to

RECEIVER iPod to operate this system or

iPod,

BD to

operate the Blu-ray disc player.

Putting the batteries in the remote
control

1

Open the battery compartment cover

on the back of the remote control.

2

Insert two AA/R6 batteries into the

battery compartment following the
indications (

, ) inside the compartment.

3

Close the cover.

Caution

Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe
the following:

• Don’t mix new and old batteries together.

• Don’t use different kinds of battery

together — although they may look similar,
different batteries may have different
voltages.

• Make sure that the plus and minus ends of

each battery match the indications in the
battery compartment.

• Remove batteries from equipment that

isn’t going to be used for a month or more.

• When disposing of used batteries, please

comply with governmental regulations or
environmental public instruction’s rules
that apply in your country/area.

• Do not use or store batteries in direct

sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

Using the remote control

Please keep in mind the following when using
the remote control:

• Make sure that there are no obstacles

between the remote and the remote sensor
on the unit.

• Remote operation may become unreliable

if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.

• Remote controllers for different devices

can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.

• Replace the batteries when you notice a

fall off in the operating range of the remote.

• Use within the operating range in front of

the remote control sensor on the display
unit, as shown.

SOUN

D R

ET

RIEVER

HDMI

PULL OPEN

7 m

30

30

LX03BD_1.book Page 9 Monday, July 28, 2008 2:12 PM

Advertising
This manual is related to the following products: