Pioneer SX-LX03 - Manual (Page 22)

Speaker Setup Guide (LX03BD) 02
22
En
Caution
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Do not connect any speakers other than
those supplied to this system.
• Do not connect the supplied speakers to
any amplifier other than the one supplied
with this system. Connection to any other
amplifier may result in malfunction or fire.
• After connecting the plugs, pull lightly on
the cables to make sure that the ends of
the cables are securely connected to the
terminals. Poor connections can create
noise and interruptions on the sound.
• If the cable’s wires happen to be pushed
out of the terminals, allowing the wires to
come into contact with each other, it
places an excessive additional load on the
amp. This may cause the amp to stop
functioning, and may even damage the
amp.
Using your own speaker cables
When connecting the speakers, you can
purchase and use your own speaker cables if
desired, in place of those furnished. In this
case, perform the following procedures to
attach the speaker cable adaptor to your own
cables:
1
• While holding down the two buttons on
the adaptor, insert the wire ends of your own
cable into the adaptor.
• White, Red, Blue, Grey and Purple speaker
cable adaptors are provided as
accessories. Use these to attach your own
cables for the front left/right speakers,
surround left/right speakers and
subwoofer.
• Use the supplied Y- cable for center
speakers connections.
• Confirm the +/– polarities of the two wires
and the corresponding markings on the
adaptor, and be sure to insert the proper
wire core into the proper side.
• After inserting the wire cores, pull gently
on the cable to confirm that the wires do
not slip out.
• Be careful to prevent the cores of the two
wires from touching each other, since a
short circuit will result.
Note
1 Speaker cables can be of sizes between 0.3 sq and 1.0 sq (equivalent to 22 gauge and 17 gauge, respectively).
Separately purchased
speaker cable
LX03BD_1.book Page 22 Monday, July 28, 2008 2:12 PM