Nortel Networks NN43001-314 User Manual
Page 205
Conversion
205
i.
Configure the Voice Gateway Media Cards. Refer to IP Line
Fundamentals (NN43100-500).
Use the same zone for DSP physical TNs and IP Phone TNs.
The zone number must match that at the main office. Refer to IP
Line Fundamentals (NN43100-500).
j.
Install and provision the local trunks (the XUT, PRI, and DTI
cards). Refer to Communication Server 1000M and Meridian 1
Small System Installation and Commissioning (NN43011-310).
k. If applicable, configure Abbreviated Dialing. See
Dialing configuration" (page 337)
.
l.
Provision the Virtual Trunks. Refer to IP Peer Networking
Installation and Commissioning (NN43001-313) .
When configuring NRS, enable the Network Connection Service
(NCS). Ensure that each Branch User ID (BUID) is entered in the
Branch Office numbering plan so it points to the main office. This
ensures that the Branch User will be properly redirected to the
main office. Refer to
"Adding the Branch Office endpoints to the
for more information.
m. Configure the IP Phones as Branch Users. Refer to
for details on Branch User Config.
—End—
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2007, Nortel Networks
.