Nortel Networks NN43001-314 - Manual (Page 260)

260 Branch Office configuration
5 Configure the parameters for IP Phone passwords and modifications.
This procedure is outlined in
"IP Phone passwords and parameters"
(page 215) .
—End—
Element Manager Branch Office zone configuration
Figure 92 "Branch Office-specific Zone Basic Property and Bandwidth
Management" (page 260)
shows the only zone configuration screen required
at the Branch Office. It is an alternative to zone configuration using LD 117.
Figure 92
Branch Office-specific Zone Basic Property and Bandwidth Management
At the Branch Office, the Branch Office Support (ZBRN) parameter must
be cleared. This parameter is only applicable to the corresponding zone at
the main office.
Adding the Branch Office endpoints to the NRS database
The Branch Office feature requires the Network Connection Service (NCS)
to redirect a Branch User to the main office. The NCS allows the TPS to
query the NRS using the UNIStim protocol, and the TPS then redirects
the Branch User accordingly. The NCS is a component of NRS, and is
enabled using the NRS Manager.
Each Branch User ID (BUID) must be entered in the Branch Office
numbering plan to point to the main office. Nortel recommends that each
BUID be a public DN (that is, a number in the public directory). Therefore,
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.