Nortel Networks NN43001-314 - Manual (Page 354)

354 Maintenance and diagnostics
Message Probable Cause Actions
Incorrect Primary or
Alternate NRS IP address
configured. Correct Primary or Alternate NRS IP address.
Primary or Alternate NRS
IP address unreachable
from this endpoint. Check network configuration and update as
required.
NCS port number is not
properly configured. Correct main office and MG 1000B NCS port
numbers.
NRS is down. Bring NRS into service.
Server Unreacha
ble (1)
Link to NRS is down. Restore Link to NRS.
Main office TPS is
unreachable from the
MG 1000B TPS. Check network configuration, and update as
required.
Main office TPS is down. Bring main office Signaling Server into service.
Link to main office TPS is
down. Restore link to main office TPS.
Main office Call Server is
down. Bring main office Call Server into service.
Server Unreacha
ble (2)
Main office node is not
registered as a SIP or
H.323 endpoint to the NRS. Register the main office node to the NRS.
Signaling Server CLI commands
This section describes Command Line Interface (CLI) commands on the
Signaling Server specific to the MG 1000B.
Refer to Signaling Server Installation and Commissioning (NN43001-312)
for a complete list of all CLI commands available on the Signaling Server.
isetShow
The isetShow command shows the type of IP Phone registration and the
registration status. This command displays general information for all
registered IP Phones.
clearLockout TN or IP
A registration lock is placed at the TPS after three consecutive failed
attempts to enter either the IP Phone Installer’s Password or the Temporary
IP Phone Installer’s Password.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.