Nortel Networks NN43001-314 - Manual (Page 258)

258 Branch Office configuration
3 Configure Vacant Number Routing (VNR).
VNR must be configured at the Branch Office. When a Branch User
is in Normal Mode, a call to that user arriving at the Branch Office will
be routed to the main office. VNR at the Branch Office and the NRS
configuration identifies the main office as the endpoint for that user.
VNR is routed through the Virtual Trunk. This enables the NRS to
centralize Numbering Plan definitions. To configure VNR, you must
configure a Route List Index (RLI) with the Digit Manipulation Index
(DMI) in LD 86 set to 0 (no digit manipulation required) on the Virtual
Trunk route.
LD 15 Configure Vacant Number Routing.
Prompt Response Description
REQ: NEW CHG Add new data, or change existing data.
TYPE: NET Configure networking
VNR YES Vacant Number Routing
- RLI 0-999 Route List Index as defined in LD 86
- FLEN 1-(16) Flexible length of digits expected
- CDPL 1-(10) Flexible length of VNR CDP
- UDPL 1-(19) Flexible length of VNR LOC
4 Configure the zone properties for IP telephony bandwidth
management. Use LD 117 or Element Manager (refer to
Figure
92 "Branch Office-specific Zone Basic Property and Bandwidth
Management" (page 260)
). At the Branch Office, this zone is used
only for bandwidth management purposes. It does not have any
associated time zone or dialing plan properties.
ATTENTION
The Branch Office zone number and zone bandwidth management
parameters at the main office must match the corresponding Branch
Office zone number and zone bandwidth management parameters at
the Branch Office.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.