Nortel Networks NN43001-314 - Manual (Page 245)

Connecting the MG 1000B Core to the network 245
Figure 88
Back of MG 1000B Core
Connect to the 10BaseT ELAN network interface port 1, or, in the case
of the MGC, the AUI port, that is connected to the Ethernet port on the
motherboard.
Use the AUI port with an Ethernet Media Attachment Unit (MAU) for the
MGC.
Port 2 and LED lights on both ports are for future use.
The two 100BaseT ports at the top right corner of the MG 1000B Core
are disconnected, as the MG 1000B MGC does not support expansion
daughterboards. Therefore, there is no TLAN network interface for the MG
1000B Core itself. The TLAN network interfaces exist only on the MG 1000B
Media Cards, IP Phones, and the Signaling Server, as shown in
Figure 11
"MG 1000B platform without MG 1000B Expander" (page 45) and Figure 12
"MG 1000B platform with MG 1000B Expander" (page 46) .
Refer to LD 117 in Software Input Output Reference - Maintenance
(NN43001-711) for IP connectivity information.
Configure login names and pseudo terminals (PTYs) for TM 3.01 and
Element Manager connectivity. You need three PTYs for Element Manager.
For the configuration procedure, see Telephony Manager 3.1 Installation
and Commissioning (NN43050-300).
The default login is
User ID: admin1
Password: 0000
This is a Level 1 password. For more information, refer to System
Management Reference (NN43001-600).
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.