Nortel Networks NN43001-314 - Manual (Page 216)

216 Main office configuration
related commands, and explanations are given in Table 19 "IP
Phone node passwords" (page 216) .
Table 19
IP Phone node passwords
Command Description
nodePwdSet Sets the node password. If a non-zero length
password is configured, all IP Phones that attempt
to register after this command is entered display
a prompt for node password before the TN can
be modified.
nodePwdShow Shows the node password settings.
nodePwdEnable Enables node password checking.
nodePwdDisable Disables node password checking.
nodeTempPwdCle
ar Deletes the temporary password and resets its
uses and time to zero.
nodeTempPwdSet Sets the node-level TN entry temporary password.
For detailed command-line or Element Manager procedures, refer to
IP Line Fundamentals (NN43100-500).
—End—
To use the Virtual Office feature, a Station Control Password (SCPW) must
be configured at both the Branch Office and the main office. This procedure
enables you to configure the length of the SCPW and the parameters
for telephone modification, such as the Set-Based Removal feature
prompts SRCD (LD 15) and AREM (LD 57). The actual SCPW password
configuration takes place while configuring the telephone data through the
overlays. Telephone data is discussed in
"MG 1000B telephones" (page
263) .
The SCPW is also used to access the user’s Personal Directory, Callers
List, and Redial List. The user can configure a second SCPW solely for
this purpose if desired. If the user chooses to use the same SCPW for
all applications, the SCPW must be the same at both the main office and
Branch Office.
Procedure 11
Setting and changing the Station Control Password Configuration
Step Action
The following steps are used to configure the SCPW.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.