Task 3: connect the router to a power source – Ringdale ISDN User Manual
Page 10
10
Task 3: Connect the router to a power source.
Step 1:
Connect the power cable, using the end with no prongs, into
the power socket on the back of the router -- see figure 5.
Figure 5
Step 2:
Connect the pronged end of the power cable into a standard
220 volts AC outlet -- see figure 5. The power light on the
front of the router should be on.
If your router is connected to the Ethernet through a
10BASE-T hub with a good-link light, be sure the light is
green (flashing or solid), indicating that your router is
properly connected to the hub. Otherwise, before going on
to Task 4, refer to the section of this manual titled
TroubleShooting.
This completes Task 3.
INSTALLING the OverLAN ROUTER
Power socket
Back of
Router
Power cable
Reset
10baseT
Serial ISDN Line
10base2