Ringdale ISDN User Manual
Page 138
138
The prompt
RARP Protocol : Disabled
will appear.
The default of RARP Protocol is Disabled.
Pressing the spacebar switches between Disabled and Enabled.
Choices:
• Disabled should be used if you do not have a RARP
server on your IP network or if you want to decide
what your local IP address and local IP mask will be.
• Enabled allows the router to dynamically petition for
an IP address and IP Mask using RARP protocol. In
other words, the local IP address and local IP mask
will automatically be assigned for your router by the
RARP server (regardless of whether they were already
assigned or not).
Press the Enter key when you are ready to continue.
The following message will appear:
Is the above setup information correct? (y/n) -
Type n to start over with this section.
Type y to use the current settings. While the settings will be
used by the router, they are not actually saved. To save the
settings, you must select SAVE from the command prompt of
the OverLAN Operating System.
You may now go to Task 6.
CONFIGURING WITH A LOCAL CONSOLE