Ringdale ISDN - Manual (Page 8)

8
METHOD 2: 10BASE-2
Step 1:
Connect a thin-coax T-plug into the 10BASE-2 port on the
back of the router -- see figure 3.
Figure 3
Step 2:
Connect a thin-coaxial cable used for the Ethernet to the
T-plug located on the back of the router -- see figure 3.
If the router is not at the termination of the Ethernet, then
connect the coaxial cable that continues the Ethernet to the
T-plug -- see figure 3.
If the router is at the termination of the coaxial cable, then
be sure that the unused end of the T-plug has a terminating
resistor; if not, attach a terminating resistor to the unused
end of the T-plug -- see figure 3.
There should be a minimum thin-coaxial cable length of
10m. Otherwise both ends of the Terminators will be too
close together, (802.2 spec).
This completes Task 1.
continuing Ethernet
Coaxial cable for
10BASE-2 Port
Terminating resistor
Back of Router
T-plug
or
Coaxiable cable
for Ethernet
Power
Serial
Reset
ISDN Line
10baseT
INSTALLING the OverLAN ROUTER