Ringdale ISDN - Manual (Page 148)

148
Task 8: Configuring a Static Routing Table
If IP Routing is not set to Enabled, then you can skip this
task and go to Task 9.
From the Setup Menu,
Press 7
to configure a static IP routing table.
The video display will appear as in figure 11:
Figure 11
IP addresses of the form _ _ _ . _ _ _ . _ _ _ . _ _ _ go in the first three
columns for Network, Subnet Mask, and Router. A number of the form
_ _ _ goes in the fourth column for Hops. Each _ _ _ is a number
between 001 and 255.
STATIC ROUTING TABLE
===================
Entry Network Subnet Mask Router Hops
------ ------------------------- --------------------------------- ---------------- -------
0
1
2
3
4
5
6
7
8
9
Command? (E = edit, D = delete, X = exit):
CONFIGURING WITH A LOCAL CONSOLE