Ringdale ISDN - Manual (Page 11)

11
Task 4: Connect the router through an NT-1 into
the ISDN phone jack.
Step 1:
Connect one end of the RJ45 cable into the BRI port on the
back of the router -- see figure 6.
CAUTION:
Be careful that you DO NOT CONNECT this cable to
the 10BASE-T port shown in the 10BASE-T Method in
Task 1.
Figure 6
Step 2:
Connect the other end of the cable to the S/T interface on
the NT-1 -- see figure 6.
Task 4 is continued on the next page.
BRI Port
(ISDN Line)
INSTALLING the OverLAN ROUTER
Back of Router
RJ45 cable
connect to
S/T interface of NT-1
Refer to the instructions
included with your NT-1,
an ISDN unit you purchase
separately
Reset 10baseT 10base2
Power
NT-1