Ringdale ISDN - Manual (Page 15)

15
METHOD 1: OverLAN Setup Wizard
Introduction
The OverLAN Setup Wizard is included in Version 1.45 and
later of OverLAN Commander 32/IP. To access the
OverLAN Setup Wizard, you must first install OverLAN
Commander 32/IP on a Windows 95/NT system with the
TCP/IP stack enabled.
To install OverLAN Commander 32/IP, do the following:
Step 1:
You should have two floppy disks for OverLAN
Commander. Insert Disk 1 into floppy drive A: of your
Windows 95/NT computer.
Step 2:
Exit all applications currently open (or running) in Windows.
Step 3:
From Windows, select Start > Run and then run
A:\setup.exe.
Step 4:
Follow all of the online instructions for installing OverLAN
Commander.
When the installation of OverLAN Commander is complete,
you are ready to run the application.
Run OverLAN Commander
From Windows, select Start > Programs > OverLAN
Commander > Commander. The OverLAN Commander
splash screen should appear followed by the OverLAN
Commander window (shown on the next page).
CONFIGURING YOUR ROUTER