Ringdale ISDN - Manual (Page 130)

130
The Prompt
Address Assignment
:
may appear beneath the previous prompt.
This option only appears if PPP IP Assignment is set to
Assigned. This is the IP address to assign to remote devices.
Choices:
• Type an IP Address to assign to devices calling in. An IP
Address should be of the form xxx.xxx.xxx.xxx where each
xxx is in the range of 1 to 256.
• Do one of the following:
• Leave this feature unchanged by not typing
anything.
• Erase the current address with the back space
key and type a new IP address.
Note: This feature has a default value of 000.000.000.000 which is not a
valid IP address. If you leave this value unchanged, devices calling in
will not gain access to the router.
Press the Enter key when you are ready to continue.
The following message will appear:
Is the above setup information correct? (y/n) -
Type n to start over with this section.
Type y to use the current settings. While the settings will be
used by the router, they are not actually saved. To save the
settings, you must select SAVE from the command prompt of
the OverLAN Operating System.
You may now go to Task 5.
CONFIGURING WITH A LOCAL CONSOLE