Ricoh AP2610N - Manual (Page 136)

Paper and Other Media
34
3
❖ ❖ ❖ ❖ OHP transparencies
• Load only one OHP transparency at the same time onto the Bypass Tray.
• When loading an OHP transparency onto the Bypass Tray, set the printer
to Transparency mode with the control panel.
• Be careful not to touch the print side of the OHP transparencies, otherwise
the print side gets dirty or damaged, and results in poor print quality.
• When printing on an OHP transparency that has a print side, load it facing
down onto the Bypass Tray.
❖ ❖ ❖ ❖ Adhesive labels
• Load only one adhesive label at the same time onto the Bypass Tray.
• Use adhesive labels in which the whole side can be printed on.
• Do not use adhesive labels having exposed glue.
• If the print side is coated, print quality might be reduced, as the toner
might not fuse well.
❖ ❖ ❖ ❖ Envelopes
• When printing on envelopes, use the Bypass Tray or the Envelope Feeder
Unit.
• Even when the optional Envelope Feeder Unit is not installed, you can se-
lect the sizes for the Envelopes for Tray 2 using the control panel. Howev-
er, you cannot load the envelopes until optional Envelop Feeder Unit is
installed.
To use the Envelope Feeder Unit, installation of the optional Paper Feed
Unit is required. See “Envelope Feeder Type 2600” in the Setup Guide.
• Specifications of envelopes are as follows:
• You can load up to 10 envelopes (72 – 90 g/m 2 , 19 – 24 lb. bond) onto the
Bypass Tray at the same time, without forcibly pressing them. Confirm
that the envelopes are not damp, and that the top of the stack is not higher
than the limit mark on the side guide. See p.45 “Loading envelopes onto
the Bypass Tray”.
• You can load up to 60 envelopes (72 – 90 g/m 2 , 19 – 24 lb. bond) into op-
tional Envelope Feeder Unit at the same time, without forcibly pressing
them. Confirm that the envelopes are not damp, and that the top of the
stack is not higher than the limit mark on the side guide. See p.47 “Loading
envelopes into the Envelope Feeder Unit”.
• Confirm that the print side is facing up when loading onto the Bypass
Tray, and facing down when loading into the optional Envelope Feeder
Unit.
Metric version Inch version
Weight 72 – 90 g/m 2 19 – 24 lb. bond
Recommended weight
and size 72 g/m 2 , 114
× 162 mm
(C6 Env)
24 lb. bond, 3 7 /
8
× 7 1 /
2
inches
(Monarch)